Quick Answer: How To Reset Service Light On Renault Clio 2016?

How do you reset the service light on a Renault?

Switch ON the ignition, don’t start the car. Press and release the top button on the end of the wiper stalk until the Service required message appears on the display.

What does spanner light mean on Renault Clio?

Upon turning on the ignition on the Renault Clio, the spanner warning light will illuminate and extinguish as soon as the engine has started. If the warning light remains illuminated whilst driving, drive carefully and consult an approved vehicle technician as soon as possible.

How do you take the service light off?

Start with the ignition turned ON (position 2), but with the engine OFF. Pull out and hold the button on the right side of the display until “SERVICE” appears on the display. Release the button on the right, then within 5 seconds pull the button out and hold it again.

How do you turn the service light off on a Renault Captur?

Scroll through the menu to “”˜Service Intervals’. Long press on the menu button will bring up something like “”˜ Service in 000 miles 00months’. Long press should reset it.

You might be interested:  Quick Answer: How To Change Headlight Bulb On Renault Megane 2014?

How do you turn off the service light on a Renault Clio Dynamique?

Push & hold button until display flashes to new service mileage. Keep button held until the spanner warning light stops flashing and let go of button. Turn the key to switch ignition off and on to check if warning light as been reset.

What does the spanner warning light mean?

The Vauxhall Corsa spanner light on the dash is essentially a warning light. It looks like a car with a spanner through it and remains it illuminated when you’ve started the ignition to signify that your car is due for a service. In this case, you should book your car in for servicing as soon as possible.

How do you turn off a Renault Clio?

Press switch 1 to deactivate the function. The message “Stop & Start deactivated” will appear on the instrument panel and the integrated warning light 2 on the switch will light up. Pressing again will reactivate the system.

Leave a Reply

Your email address will not be published. Required fields are marked *